PROTOTYPE SWITCH OTOMATIS PADA KAMERA GAMMA DENGAN PENGENDALI JARAK JAUH BERBASIS ARDUINO
Sari
The use and use of radioactive and in the industrial sector, is increasing in Indonesia. Radiography and one of them, is used to examine the structure and quality of materials, using the Non-Destructive Test method. Currently, gamma cameras are still used, manually, namely the operator who operates the camera directly, and causes health problems by gamma ray radiation.
One solution is to design a control system on a gamma camera, for that, several components are needed to produce the desired work system. The components used for the system are Arduino Uno, radio frequency and servo motors.
As for activating, it begins by pressing a switch to open or close the gamma camera in order to minimize health hazards from gamma ray radiation, Prototype is made with a ratio of 1: 2.Red LEDs, green LEDs, and LCDs are used as indicators for operators that the device is well connected System measurement testing, carried out with radio frequency with and without hindrance to variations in distance of 5 m, 10m, 15m, 20m and 25m, the system can still work, and is well connected.
Keywords: gamma camera, arduino uno, radio frequency.
Teks Lengkap:
PDFReferensi
Basyiroh Nurul,Politeknik negeri bandung,Realisasi system notifikasi untuk efisiensi respon permintaan ambulance di ksr pmi kota bandung menggunakan modul radio 2,4 GHZ berbasis visual basis 6.0 (bagian komunikasi radio dan interface),2017.
Dinata, Yuwono Marta.2015.Arduino Itu Mudah. Jakarta: PT. Alex Media Komputindo.
Drs.Sujarwata,M.T,2012.Belajar Mikrokontroler BS2SC Teori, Penerapan dan contoh pemrograman Pbasic. Yogyakarta:Deepublish
Fadhil Puri Himawan, Unang Sunarya, Dwi Andi Nurmantris.2017. Perancangan alat pendeteksi asap berbasis mikrokontroller modul gsm, sensor asapm dan sensor suhu.
Ilfan Arifin.2015.Automatic water level control berbasis mikrokontroller dengan sensor ultrasonic.Universitas Negeri Semarang
PROGRAM PROTEKSI RADIASI BIDANG RADIOGRAFI INDUSTRI DIPUSDIKLAT BATAN , B.Y Eko Budi Jumpeno ,2000
Rizky Putra Pratama, Sabriansyah Rizqika Akbar, Adhitya Bhawiyuga:2017 Rancang bangun low power Sensor Node Menggunakan MSP430 berbasis NRF24L01
Saludin Muis, Dr.Ir.M.Kom.2012, Prinsip Kerja LCD dan pembuatannya (Liquid Crystal Display)Jakarta: Graha Ilmu
SERTIFIKASI ULANG KAMERA RADIOGRAFI GAMMA INDUSTRI JENIS PORTABLE , B.Y Eko Budi Jumpeno , 2013
Cara Kerja I2C. Diakses pada tanggal 19 Desember 2019 disitus
https://www.innovativveelectronics.com/fitur-i2c /.comhtml
DOI: https://doi.org/10.35968/jti.v9i0.658
DOI (PDF): https://doi.org/10.35968/jti.v9i0.658.g629
Refbacks
- Saat ini tidak ada refbacks.
Indexed by: